B-2 Parameters, Settings, and Defaults
2325 Reference Guide Revision B 2325A137REFGD
all maximum lengths to the highest values. This default set
is normally used only for troubleshooting. It gives you the
best chance of reading an unknown barcode symbology
and also identifies the symbology of each barcode you
scan.
Predefined Default 2 (D2) is the default set that was
installed in the 2325 at the factory. This default set will
work for most applications. If you have changed any
settings and want to reset the 2325 to the original defaults,
scan the D2 barcode in Appendix C.
Parameters, Settings, and Defaults
Enter 1 for On and 0 for Off.
Code 39
Defaults
Code Parameters I.D. # Type Acceptable Input D0 D1 D2
Enable 00 On/Off On or Off Off On On
Minimum length 01 Value 00–50 00 00 00
Maximum length 02 Value 01–50 01 50 20
Enable checksum 03 On/Off On or Off Off Off Off
Send checksum 04 On/Off On or Off Off Off Off
Full ASCII mode 05 On/Off On or Off Off On On
