The Single Dock 7-3
2325A137REFGD Revision B 2325 Reference Guide
Figure 7-2 Back Panel of the Single Dock
1 Power input jack
2 Cable connector
The Power Adapter
Important: If the 2325 contains non-rechargeable batteries, do not
connect the power supply to the dock.
You can use a 9-volt power adapter with the Single Dock to recharge the
batteries in the 2325. Power adapters are available from LXE.
Attach the small, round plug of the power adapter to the power input
jack on the back of the Single Dock. Plug the other end into an AC
outlet or power strip. The red light-emitting diode (LED) labeled
POWER
on the front panel of the Single Dock should light up.
The power adapter is used only to recharge the batteries in the 2325.
However, if you do not use it, the LED indicators on the Single Dock
will not light up. (The
READY
light indicates that the 2325 is properly
inserted in the dock. The
READY
light will appear red when charging
2325 batteries and green when batteries are fully charged.)
Note: Use only a 9-volt power adapter supplied by LXE. Using
another adapter can damage the dock.
