Resetting the 2325 2-5
2325A137REFGD Revision B 2325 Reference Guide
The unit indicates safe-boot mode by emitting a low tone followed by a
higher-pitched tone. The flash drive (C) and the RAM drive (D) will be
preserved, and the boot sequence will place the unit at the C:\> prompt.
Note: If you do not hear the two tones indicating the safe-boot
sequence, you probably did not press the ESC and DEL keys
quickly enough. Reboot the 2325 and press the two keys
simultaneously as soon as you see the “Wait…” message on
the display.
Hardware Reset
In the extremely rare situation where none of the rebooting methods is
successful, you can use a reset mechanism that is located under the PC
card slot cover. Touch a metal device (such as a paper clip) to the two
metal contacts on the reset mechanism. This will cause the 2325 to begin
a cold boot.
Note: Metal must touch metal before the 2325 will reset.
Figure 2-2 Location of the Hardware Reset Mechanism
Upon reset, you will need to set the date and time in the 2325. These
DOS programs may run automatically after a Hardware Reset.
