Filter
Top Products
42 K400 Issue No. 1
Resistance Measurement
The DBC-TC series can directly measure the resistance value of an RTD under test.
From the Menu Selection Screen, select Ohm in the MEASURE section using the
keys and press ent. After selection of the temperature generation mode,
the next display sets the connected RTD as a 3 or 4 wire device.
Using the select the required connection and press ent. The final working
screen shows the generated temperature in the lower part of the display and the
measured Ohmic value in the top part.
MEASURE
INTERNAL
SEL RTD
mV
V
Ohm
REF T.
RTD
3 WIRES
4 WIRES
Ohm
RDG:
138.50
150.00 DIRECT
BLK
°C
100.00
Ω