Filter
Top Products
K400 Issue No. 1 i
Introduction
• This technical manual provides operating instructions for the Druck
DBC Series of Dry Well Calibrators.
Safety
• The manufacturer has designed this equipment to be safe when
operated using the procedures detailed in this manual. Do not use this
equipment for any other purpose than that stated.
• This publication contains operating and safety instructions that must be
followed to ensure safe operation and to maintain the equipment in a
safe condition. The safety instructions are either warnings or cautions
issued to protect the user and the equipment from injury or damage.
• Use suitably qualified * technicians and good engineering practice for
all procedures in this publication.
Test leads
• Only use the test leads supplied with the instrument, do not use these
test leads with any other equipment.
Power isolation
• Access to the power supply isolator switch must not be obstructed.
Toxic Materials
• There are no known toxic materials used in construction of this
equipment.
Maintenance
• The equipment must be maintained using the procedures in this
publication. Further manufacturer’s procedures should be carried out
by authorized service agents or the manufacturer’s service
departments.
Technical Advice
• For technical advice contact the manufacturer.
*A qualified technician must have the necessary technical knowledge,
documentation, special test equipment and tools to carry out the required
work on this equipment.
This equipment meets the requirements of all relevant
European safety directives. The equipment carries the CE
mark.