4 - 11
3 Engine Maintenance Mode
Note:
This mode is used only by service persons, and it should not be released to the end
users.
To enter into the engine maintenance mode, turn the POWER switch on while holding the
FORM FEED and ENTER keys down.
Function
There are following functions :
• Head drive time setting • Drum count total display
• Printing start position setting • Engine reset
• Drum count display • Factory adjustment
• LED head width setting • LED head type setting
(Adjustment method for adjustment head)
• Transfer current setting • Optical LED head (Mounting head type)
• Setting of strobe time
• Selection of standby temperature
• Engine test
Note:
"Printing start position setting" is for shipping. Do not change its default value.
Detailed descriptions of these functions are provided in Appendix C, DIAGNOSTICS
TEST.
