C - 6
(j) Standard tray paper feed setting
• Do no change its default setting since this is a factory setting and were set at the
factory.
(k) Second tray paper feed setting
• Do no change its default setting since this is a factory setting and were set at the
factory.
(l) Second tray download table selection
• Do not change its default setting since this is a factory setting and were set at the
factory.
(m) Multi-purpose feeder setting
• Do not change its default setting since this is a factory setting and were set at the
factory.
(n) Multi-purpose feeder download table selection
• Do not change its default setting since this is a factory setting and were set at the
factory.
(o) Setting of standby temperature
(p) Engine test selection
• Do not change its default setting since this is a factory setting and were set at the
factory.
(q) Engine reset
• All EEPROM areas used by the engine block are reset to the factory default values.
The following items are excluded.
• Menu level-1
• Menu level-2
• Operator panel menu disable/enable
• Head drive time setting
• Head width setting
• Head type setting
• Transfer current setting
• Page print disable/enable
• Transition to the operation mode occurs completion of resetting.
