A SERVICE OF

logo

3 - 9
3.3.3 LED Head
(1) Open the stacker cover.
(2) Remove the flexible cable (LED) 1 from the PC connector 2 of the LED head 3.
(3) Remove the LED head by prying the left side free from the retaining clip.
Note:
Be careful to not lose the contact (LED) 4.
Note:
Be sure not to directly touch or push the SLA part of the LED head.
After mounting the new LED head, set drive time of the LED head according to the
marking on the LED head (see 4.3.1 or 4.3.2).
For the installation of the flexible cable (LED) 1, install the PC connector 2 to the
flexible cable (LED) 1 first, then connect the LED head 3 to the PC connector.
When installing a new LED head, be careful not to lose the contact (LED) 4.
3
SLA part
2
1
3
4
3
2
1
OKIPAGE 6ex
OKIPAGE 6e