6 - 27
■■■■■■■■
■■■■■■■■
▼
INITIAL-
IZING
▼
ON-LINE
Adobe PS
1-2 The printer does not work normally after the power is turned on. (OKIPAGE 6ex PS mode)
• Turn the power off, then back on.
• Is all ■'s message being displayed by the LCD display?
• No Is the AC cable being connected properly?
• No Connect the cable properly.
▼
• Yes Is +5 V being applied between pins 2 and 5 of CN5 on the Main Control
PCB?
Pin 2 : 0 V
Pin 5 : +5 V
B
• No Is the connection between connector CN7 on the main control
board and connector CN3 on the power supply board made
properly?
No Correct the connection.
▼
• Yes Go to
A
.
▼
• Yes Is +8 V being applied between pins 24 and 16 (GND) of connector CN7?
• No Go to
B
.
▼
• Yes Is the flexible cable for the operator panel assy being connected to the
connector CN5 on the Main Control PCB and the connector CN1 on the
OLCC board properly?
• No Connect the flexible cable properly.
▼
• Yes Replace the operator panel assy or flexible cable.
▼
• Remedy?
• No Replace the Main Control PCB.
▼
• Yes End
▼
• Yes Is message being displayed by the LCD display?
• No Replace the Main Control PCB.
▼
• Yes Is message being displayed by the LCD display?
• No Take actions following the LCD message list (see 6.5.1 for correct
actions).
