A SERVICE OF

logo

6 - 32
[JAM error]
2-3 Paper exit jam
• Does the paper exit jam error occur when the power is turned on?
• Yes Is the paper on the outlet sensor lever?
• Yes Remove the paper.
• No In the operation of the outlet sensor lever normal (moves freely when
touched)?
• No Replace the outlet sensor lever.
• Yes Clean the outlet sensor on the power supply board or replace the power
supply board.
• No Is the face-up stacker pulled out completely from the printer or, pushed into the
printer completely?
• No Pull the face-up stacker out of the printer completely or push it into the printer
completely.
• Yes Is the eject roller assembly being installed properly?
• No Install the eject roller assembly properly.
• Yes Has the coil spring come off the eject roller assembly?
• Yes Install the coil spring to the eject roller assembly.
• No Replace the eject roller assembly.