208 Power Tools EZConfig Utilities
MX6 Reference Guide E-EQ-MX6RG-E-ARC
Symbologies
The Symbologies settings specify the settings for each of the symbologies supported by the
MX6’s decoder.
See Chapter 6 “Scanner\Imager Parameter Setup” for explanations of barcode parameter settings.
The settings are in the form:
Symbology Name= Enable, Parm1, Parm2, Parm3, Parm4, Parm5, Parm6, Parm7, Parm8
Where:
• Enable (0=Disable or 1=Enable): Specifies if the symbology is enabled or disabled.
Disable symbologies not used to improve performance.
• Parm1...8: Specify the settings for the symbology, as documented in the HHP Decode
API. Unused parameters are ignored.
Example:
Code 39 = 1,0,0,0,0,0,2,48,0
1 = Enable Code 39
0 = Don't transmit start and stop characters
0 = Read codes with or without check character
0 = Do not transmit check character
0 = Full ASCII mode is disabled
0 = Append mode is disabled
2 = Minimum length is 2 characters
48 = Maximium length is 48 characters
0 = Ignored parameter for Code 39
Key (*Default Selected/Active) Demo File Value
SCANCONFIG.INI
Default Value
Aztec Code * 1,1,3750,0,0,0,0,0,0 1,1,3750
Aztec Mesas 0,0,0,0,0,0,0,0,0 0,0,0,0,0,0,0
Codabar * 1,0,0,0,4,60,0,0,0 1,0,0,0,2,60
Code 11 0,1,4,80,0,0,0,0,0 1,1,4,80
Code 128 / EAN 128 * 1,0,80,0,0,0,0,0,0 1,0,80
Code 39 * 1,0,0,0,0,0,0,48,0 1,0,0,0,0,0,2,48
Code 49 * 1,1,81,0,0,0,0,0,0 1,1,81
Code 93 * 1,0,80,0,0,0,0,0,0 1,1,81
EAN.UCC Composites 0,1,300,0,0,0,0,0,0 1,1,300
