Settings Options 135
E-EQ-MX6RG-E-ARC MX6 Reference Guide
Network Name and Type
SSID Enter an SSID, which is the Network Name. Check with your network
administrator for Network Name (SSID).
TX Rate Choose 1Mb, 2 Mb, Auto 1/2 Mb, 5.5 Mb, 11 Mb, or Fully Auto from the menu.
The transmit rate is Fully Automatic by default.
Type Choose from Peer-to-Peer or Access Point in the pull down menu. Access Point
mode is also called “Infrastructure” mode. Peer-to-Peer mode is used for
communication between two (or more) radios (cards) without an access point.
Chan Channel. Scroll to select a channel for communication.
WEP Parameters
Configure the WEP Key for secure wireless communication.
Method Select one of the five options from the pull down list:
Disabled WEP Key Off
64 bit (HEX) up to 10 characters configurable in Hexadecimal for
Encryption Key
64 bit (ASCII) up to 5 characters configurable in ASCII for
Encryption Key
128 bit (HEX) up to 26 characters configurable in Hexadecimal for
Encryption Key
128 bit (ASCII) up to 13 characters configurable in ASCII for
Encryption Key
Note: HEX, Hexadecimal number set of 16 digits from 0-9 and from
A(a)-F(f). ASCII: Any printable ASCII character.
Key ID Choose from the available options:
Key 1 (Default)
Key 2
Key 3
Key 4
Encryption Key Different character set depending on different WEP method and key
format.
Authentication
Algorithm
Automatic based on WEP settings is the default.
802.1X Default is Disabled.
Tap OK to make the changes, close this screen and save the changes. Tap Cancel to ignore all
changes made on this screen.
Tap the Advanced button to set AP Search Threshold. LXE recommends setting this value to
either Medium or High Density. Low Density is the default.
