110 Settings Options
MX6 Reference Guide E-EQ-MX6RG-E-ARC
Version 7.11 and 7.13
Access: Start | Settings | System tab | Scanner
The Keyboard Wedge Control panel allows the user to configure a user-defined sequence of
ASCII characters (printable) and control characters in Block Mode and Key Message modes.
Factory Default Settings
Main
Enable internal scanner Enabled
Send Key Messages (WEDGE) Enabled
Tethered scanner on COM 1 Disabled
Enable Internal Scanner Sound Enabled
Enable Output (Ver 7.13) Dimmed
Advanced
Translate Control Codes Disabled
Strip Leading characters Zero
Strip Trailing characters Zero
Key Message Prefix Disabled
Key Message Suffix Disabled
Control Characters (Ver 7.13)
Translate All Disabled
Char Assignment ACK
Char Replacement Ignore
COM 1
Baud Rate 9600
Data bits 8
Stop bits 1
Parity None
Version 7.13
Adjust the settings and tap the OK box to save the changes. The changes take effect immediately.
Enable Internal Scanner The default setting is Enabled. Disable this parameter when running
the Scan Demo or Imaging Demo programs in Start | Demos.
Send Key Messages
(WEDGE)
The default setting is Enabled. This feature coexists with the
Prefix/Suffix features and the Strip Leading/Strip Trailing features.
Tethered Scanner on
COM1
The default setting is Disabled. Enable this parameter when a
tethered scanner is connected to the serial connector at the base of
the mobile device (or to a cradle when the mobile device is docked
in a cradle).
Enable Internal Scanner
Sound
The default is Enabled. Disable this parameter when good scan/bad
scan sounds are to be handled by alternate means e.g. application-
specific WAV files.
Enable Output
(Ver 7.13)
This parameter is disabled unless “Tethered scanner on COM1” is
enabled. When both parameters are enabled data can be output to a
device connected to the serial connector at the base of the mobile
device; or to a cradle when the mobile device is docked in a
powered cradle.
