Filter
Top Products
94
5. Tumbler/Basket Electrical Component(s)
a. Tumbler (Basket) Thermal Magnetic Starter and Auxiliary Contact Block Replacement
1) Discontinue electrical power to the dryer.
2) Mark and identify the wires that will be removed for proper reinstallation.
3) Set the control of the thermal magnetic starter to the stop position.
4) Press down on the thermal magnetic starter and lift the bottom up and out of the din mounting rail.
5) Mark and identify the wires that will be removed for proper reinstallation.
6) Remove
ALL associated wires.
7) Separate the thermal magnetic starter from the auxiliary contact block.
8) Install new thermal magnetic starter or auxiliary contact block.
9) Reassemble the thermal magnetic starter to auxiliary contact block.
10) Set overload to required setting.