Filter
Top Products
107
2) Failure in drive motor circuit.
b. Faulty rotation sensor.
c. Broken wire or connection between rotation sensor and microprocessor controller (computer) display
board.
d. Failure in rotational sensor circuit or magnet missing or gap too large.
e. Tumbler (Basket) rotation below 12 RPMS.
P. Microprocessor controller (computer) reads Exhaust High Temp Fault...
1. Possible overheating condition...microprocessor controller (computer) display board has sensed a
temperature which has exceeded 225º F (107º C).
Exhaust High Fault Temp will display until the stop key has been passed. A cycle
cannot be started until
the temp is below 220º F (104º C).
Q. Dryer operates but is taking too long to dry...
1. Exhaust duct work run is too long or is undersized...back pressure cannot exceed 0.3 inches water
column (W.C.) - 0.74 mb.
2. Restriction in duct work...check duct from the dryer ALL the way to the outdoors.
3. Low or inconsistent gas pressure (for GAS MODELS ONLY).
4. Insufficient make-up air.
5. Poor air and gas mixture at burner - yellow or poor flame pattern...adjust gas burner air adjustment
shutters (for GAS MODELS ONLY).
6. Lint drawer or screen is not being cleaned on a regular basis or often enough.
7. Extractors (washer) is not performing properly.
8. Sail switch is fluttering...restriction in exhaust (for GAS MODELS ONLY).
9. Failed microprocessor controller (computer)...temperature calibration is inaccurate.
10. Failed microprocessor temperature sensor...calibration is inaccurate.
11. Failed burner hi-limit (for GAS MODELS ONLY).
12. Failed 225º F (107º C) manual reset hi-limit (thermostat).