Filter
Top Products
Cod. G522441
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 02/0510
Service removal 62
14.6. VERIFYING THE SAFETY MECHANISMS
Verifying the door lock
DAILY check the safety mechanism on the door lock
CAUTION
Use great prudence in checking the safety mechanisms.
Carry out the verification described in following while the drum is turning at washing speed and never at a
higher speed.
If there is a failure in the door lock, never place one’s hand in the loading area of the washer.
Verification procedure:
Disconnect the ON/OFF switch. The washing machine screen is off.
Close and mechanically interlock the manual water supply valves (and steam inlet valve in washers with
this option included.)
Open the washing machine door.
Connect the ON/OFF switch. On the screen the door open icon is displayed.
Close the door. Select and start a wash cycle.
After about a minute from starting the cycle, check that the door is locked.
Press the STOP key to finish the verification.
After a safety delay of no more than 30 seconds, the door will be unblocked.
The verification is finished.
If no anomaly has been detected, open the fluid inlet valves.
CAUTION
If noticing anything other than what was described during the operation, disconnect the washer, do not
use it, and URGENTLY contact the Authorised Technical Service.
Verifying the Emergency Push-Button (Appliances with Emergency Push-Button only)
WEEKLY check the Emergency Push-Button.
Verification procedure:
Connect the ON/OFF switch. On the screen the door open icon is displayed.
Close the door. Select and start a wash cycle.
After about a minute from starting the cycle, activate the EMERGENCY button. The buzzer will sound and
the drum will stop rotating. On the screen the Emergency Push-button activated message is displayed.
Unlock the emergency button turning it in the direction of the arrows and press START on the multifunction
keyboard to resume the machine’s operation.
After a safety delay of no more than 3 minutes, the machine operation is resumed.
Press the STOP key to end the washing cycle. The verification is finished.
CAUTION
If noticing anything other than what was described during the operation, disconnect the washer, do not use it,
and URGENTLY contact the Authorised Technical Service.