Filter
Top Products
Cod. G522441
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 02/0510
Modifying programs 36
8. MODIFYING PROGRAMS
The objective of this menu is providing the user with resources that allow:
modifying programmed programs
programming new programs from the copy and modifying programs in use
eliminating programs out of use with the objective of maintaining the maximum capacity of the
microprocessor memory.
Some of the options offered by the MODIFICATION menu are grouped into submenus.
General map of the MODIFICATION menu
Modifying the content of a phase
Inserting a phase before the phase
selected
Inserting a phase after the phase
selected
Modifying a program (section
8.1):
Selecting the program
Option to modify the program
number
Selecting the phase
Four submenus will later appear.
Erasing a phase
Copying an existing program into a new program (section 8.2)
Blocking an existing program from operating (section 8.3)
Erasing an existing program (section 8.4)
8.1. MODIFYING A PROGRAM (from number 21)
Modification options:
Modifying a program name
Modifying the content of a phase
Inserting a phase
Erasing a phase
8.1.1. Selecting a program and modifying the name
From the main menu (section 4.1), select the icon corresponding to the PROGRAMMING mode
(section 6.3). The icons of different menus appear.
Select the MODIFICATION icon.
The icons of different modification options will appear.
Consult the general map of the MODIFICATION menu in the start-up section of chapter 8.
Select the MODIFYING A PROGRAM icon. The list of programs will appear.
Select the program that you want to modify.
Confirm the selection.
The modifying program name screen is displayed. If you want to introduce or modify the
program name, continue on this screen following section 7.2. Confirm the modification.
The following screen appears.