Filter
Top Products
Cod. G522441
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 02/0510
System tools 48
10.2.3. Modifiable values tables
BATH LEVELS
Modifying the value of the six bath levels within the established limits is possible, always respecting the
ordering criteria from lowest to highest. The value of each level in millimetres must always be higher than
the lower level and smaller than higher level.
The programmed height of the bath is approximately equivalent to the height of the water visible through the
lower part of the drum, expressed in millimetres.
These values must be checked with the drum stopped (programming NO rotation in the phase).
Values programmable by the numerical keyboard
Programming limits
and table of values configured at works depending on the machine model.
programmable ranges
LEVEL level values by default in mm.
minimum maximum
L1 8 L1 L2 – 1mm
L2 75 L1 + 1mm L3 – 1mm
L3 143 L2 + 1mm L4 – 1mm
L4 205 L3 + 1mm L5 – 1mm
L5 263 L4 + 1mm L6 – 1mm
L6 323 L5 + 1mm d / model
Example of programming levels > >
Programmable L3 (level 3) range:
min: L2 + 1= 79mm.
max: L4 – 1= 139mm.
ATTENTION!
Increasing the bath levels increases the water and energy consumption of the washing machine.
The habitual usage of the bath level greater than the default value of level 6 considerably reduces the
life of the seals and bearings.
Do not increase the level values if it is not absolutely necessary.