Filter
Top Products
Cod. G522441
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 02/0510
Modifying programs 39
8.3. BLOCKING AND UNBLOCKING THE USE OF A PROGRAM
Option that allows impeding the use of one or more selected programs.
Blocking usage
From the main menu (section 4.1), select the icon corresponding to the PROGRAMMING mode
(section 6.3). The icons of different menus appear.
Select the MODIFICATION icon.
The icons of different modification options will appear.
Consult the general map of the MODIFICATION menu in the start-up section of chapter 8.
Select the BLOCKING icon. The program list will appear.
Select the program you want to block.
Press the SEL key to confirm the order of blockage. The blocking icon appears next to
the selected program number, indicating that the program cannot be executed.
The machine is ready again to block a new program.
To unblock a blocked program, select the program and press the
·SEL key. The blocking icon will disappear.
To quit the option, access the upper menu by pressing the ------ key.
8.4. ERASING A PROGRAM
Eliminate the content of programs programmed by the user (from number 21).
Before executing the order, the microprocessor requests confirmation to erase. If erasure is confirmed, the
content of the program is IRRECOVERABLE.
The content of the first twenty programs cannot be erased.
Erasing a program
From the main menu (section 4.1), select the icon corresponding to the PROGRAMMING mode
(section 6.3). The icons of different menus appear.
Select the MODIFICATION icon.
The icons of different modification options will appear.
Consult the general map of the MODIFICATION menu in the start-up section of chapter 8.
Select the ERASE icon. The program list will appear.
Select the program you want to erase. Confirm the selection.
The following screen prompts confirmation to erase.
Confirm to erase the program contents.
The machine is ready again to erase a new program.
To quit the option, access the upper menu by pressing the ----- key.
8.5. MODIFYING THE NAME AND VIEWING THE CONTENT OF PRE-SET PROGRAMS (from
numbers 1 to 20)
The twenty pre-set programs are not modifiable; however, modifying the name and/or viewing their
content is possible.
Once a phase is selected, the icon indicates that modifying its content is not possible.
The ··OK·· key allows successively viewing the content of the phase.
To finalize viewing the content of the phase, accessing the end of phase screen (7.3.16) is
imperative.
?