Filter
Top Products
Cod. G522441
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 02/0510
Programming mode 25
6. PROGRAMMING MODE
6.1. DEFINING PROGRAMMING CONCEPTS
Before programming new programs, it is important to be familiar with the main concepts involved in the
process.
To understand the structure of Microprocessor Control wash programs, two basic concepts must be defined:
function and phase.
Function: Each action performed by the washing machine during a program. Highlighting the most
important ones: filling with water, dosing of product, drum movement, draining... The functions are always
performed following the same sequence or order of execution.
Phase: The grouping of the functions in the order in which they are performed is defined as a phase. The
total number of phases available in the Microprocessor Control memory will vary depending on the
options defined in Configuration.
Association of phases: The great potential of this system lies in the possibility to program
interconnected phases, since not all the phases must necessarily finalize with a draining of the bath.
This feature allows carrying out modifications, within the same phase, such as: increasing the level or
temperature of the bath, dosing products at different moments within the same bath, varying the
mechanical action, etc.
Program: Group of phases grouped together in a defined sequence whose execution has the treatment
of the fabric as its objective. The maximum number of phases in each program is not previously defined.
Programming: programming is filling with content the functions that make up the phases of a program. It
can be done from an empty structure: programming anew program or modifying an already existing
program.
It must be mentioned that programs 1 to 20 are programmed at works and their content is unalterable.
There is, however, the possibility of copying them over an empty program and later modifying them.
Configuration: The SYSTEM TOOLS menu of Microprocessor Control contains those parameters
determining the washing machine operation. Modifying the value of these parameters the operation of the
washing machine can be adapted to the needs of the users and using the machine’s possibilities to the
maximum.
By default, the washing machine leaves the factory with the basic configuration of operation options.
This configuration permits programming the washing machine with many possibilities but with great
simplicity.
Do not modify the configuration parameters without knowing exactly what the objective of the
washing machine operation is.
6.2. PROGRAMMING MODE MENUS
The PROGRAMMING mode screen allows choosing different options:
Programming a new program
Modifying existing programs
Using the card