Filter
Top Products
Cod. G522441
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 02/0510
Safety instructions 3
16. WARNING!
MACHINE INSPECTION, FILTER CLEANING, MAINTENANCE, SERVICE OR PARTS REPLACEMENT.
Before attempting any service or inspection of the washing machine:
Close and mechanically interlock the water supply valves and check that machine has COMPLETELY
drained, parts have cooled down and that no pieces are in movement through inertia.
To reduce the risk of electrical shock:
COMPLETELY disconnect the machine from the original power source and check for accidental
reconnection. MOVING THE ON SWITCH TO THE OFF POSITION IS NOT SUFFICIENT.
Disconnect the electrical power of the external dosing to the washing machine. These circuits are
independent of the washer’s supply.
Wait a minimum of (5) five minutes after disconnection to ensure the elimination of residual voltage
within the machine.
Failure to comply with this warning may result in serious injury.
17. NEVER START THE MACHINE NOR USE IT IN THE ABSENCE, INCORRECT POSITION OR
MALFUNCTION OF:
COVERS ( GUARDS) AND PROTECTIONS
SAFETY DEVICES
CONTROL ELEMENT
18. The room MUST comply with the environment conditions (air venting, temperature, humidity...) specified in
the Installation Instruction Handbook. NEVER INSTALL THE WASHING MACHINE in very humid
environments or with water splashes.
19. DO NOT OPERATE the machine if it is suspected to be faulty, either visually, by noise or smell, or with
missing or broken parts.
20. Machine start-up SHALL be made by Authorised Service Technicians (refer to note 2).
21. Machine SHALL BE USED by qualified personnel (refer to note 1), wholly familiar with the machine’s
operation.
22. DO NOT allow children or people with handicaps incompatible to machine use to operate machine.
23. Every machine working with temperature has a fire hazard, take SPECIAL care. KEEP appliance area free
from combustible materials and fire extinguishers should be PLACED near the machines and should be
easily accessible to all laundry staff.
24. Delimitate danger areas and PREVENT public access to them with machine in operation. Do not expose
yourself to the dispenser, drain and rear overflow steam exhaust
.
25. On completion of the day's work, TURN OFF the manual supply valves and DISCONNECT the electrical
power by the External Automatic Switch.
26. Always CONTACT an Authorised Service Technician or Licensed Installer (refer to notes 2 & 3) about any
problems or conditions you do not understand.
27. For a safe operation, machine MUST be kept in a good environment, used and maintained properly. We
recommend asking annually the Authorised Technical Service for a thorough overhaul (refer to note 2).
28. The Distributor (seller) IS OBLIGED to thoroughly train the operator during the starting-up.
THE MANUFACTURER REFUSES ANY RESPONSIBILITY IF THESE SAFETY INSTRUCTIONS AND ALL
INFORMATION IN THE CORRESPONDING HANDBOOKS ARE NOT FOLLOWED.
SAVE THESE INSTRUCTIONS
NOTES:
(1) Qualified Personnel refers to anyone who has read the Instructions Handbooks, has been trained and has a thorough understanding
of the machine’s operation
(2) An Authorised Service Technician (AST) is one that has successfully completed training on the product by the manufacturer or a
manufacturer Distributor.
(3) An Authorised Licensed Installer is one that is suitably qualified in the procedures and regulations applicable in that country.