Filter
Top Products
6-7
Press and release:
EXTRA RINSE
Door locks, lid lock indicator turns on.
Repeat Door unlocks, lid lock indicator turns off.
•
•
Manual: Door Lid Switch
Opening the door should cause the Clean
status indicator to turn off. Closing the door
should cause the indicator to turn on.
If Clean indicator does not turn off or on, go
to TEST #8.
Manual: Door Lid Lock
NOTE: Door must be closed. If door is not
closed, an invalid button press beep will oc
-
cur when performing next step.
•
If door does not lock or unlock, go to TEST
#8.
•
Press and release:
SPIN SPEED, or
LOAD SIZE
Motor/basket spins at 23 rpm.
Repeat Motor/basket spins at 530 rpm.
Repeat Motor/basket spins at 1000 rpm.
Repeat Motor turns off.
•
•
•
•
Press and release:
SOIL LEVE
L
Gentle wash action.
Repeat Normal wash action
.
Repeat Heavy wash action.
Repeat Motor turns off
.
•
•
•
•
Manual: Motor
Rotor Position Sensor (RPS): Uses Wash,
Rinse and Spin indicators to detect the three
hall sensors. Console may have up to two of
these indicators on at one time when the bas
-
ket is not moving. Open door and rotate bas
-
ket by hand. The Wash, Rinse and Spin status
indicators should toggle on and off according
to direction the basket is being turned.
If none of these indicators are on go to
TEST #3.
Spin: To activate Spin, door must be closed
with door lock enabled. See Manual: Door Lid
Lock.
NOTE: If door is not closed, an invalid button
press beep will occur when performing next
step.
•
Agitate: Water must cover the wash plate (or
agitator vanes) to ensure the basket is float
-
ing prior to agitation. Enabling agitation with
-
out enough water may cause a fault condition
to occur. See Manual: Water Valves.
NOTE: Indicators above button scroll from
top to bottom.
If motor fails to agitate, go to TEST #3.•
NOTE: Indicators above button scroll from
top to bottom.
If motor fails to spin, go to TEST #3.•
ACTIVATION OF CONSOLE AND
INDICATORS DIAGNOSTIC TEST MODE
This test checks the cycle selector knob, indi
-
cators, buttons, two-digit display and beeper.
1. Plug in washer or reconnect power.
2. Read through step 3 before continuing.
From Standby (Off) Mode press and re
-
lease (key-dance) the following buttons
within 4 seconds:
If successful, two-digit dt will display and
you will have 5 seconds to complete next
step.
3. Within 5 seconds of dt showing in display,
press START (all indicators in display are
illuminated and 88 is displayed).
Press START a second time. This
turns off status indicators and two-digit
display (all other indicators remain il
-
luminated).
Press START a third time. This turns
on status indicators and two-digit dis
-
play (all indicators are illuminated).
4. Rotate WASH CYCLE selector back and
forth. Indicators will toggle on (or off).
•
•
SOIL
LEVEL
WASH/RINSE
TEM
P
SOIL
LEVEL
WASH/RINSE
TEM
P