Filter
Top Products
4-18
6. At the right rear corner of the washer,
reach down and pull the pressure trans
-
ducer tube off the tank.
7. Lower (do not latch) the top of the cabi
-
net.
8. Carefully lay the washer on its front pan-
el. Place padding on the floor to protect
the surfaces.
9. Remove the drain and recirculation pumps
(see page 4-13 for the procedures).
10. Remove the drive motor (see page 4-15
for the procedure).
Pressure Transducer Tube
11. Pull the tub out of the bottom of the washer.
12. Remove the two 5/16˝ hex-head screws
from the counterbalance weight and re
-
move the weight from the tub.
13. Loosen the clamps and remove the recir
-
culation and drain hoses from the tub.
14. Remove the hex-head clamp screw from
the recirculation outlet hose extension,
and remove the extension from the side of
the tub.
Counterbalance Weight
Drain Hose
Recirc. Hose
Recirculation Outlet Hose Extension
Washer Tub