Filter
Top Products
3-10
EXTRA RINSE
An extra rinse can be used to aid in the removal
of detergent or bleach residue from garments.
This option provides an additional rinse with
the same water temperature as the first rinse.
This is the default rinse setting for the Whites
cycle.
PRE SOAK
Use this option for set-in stains and soil that
need extra time for removal. Soaking in this
washer is different than in a conventional
washer. The washer sprays the load with water
and detergent at extra-low spin speed followed
by a brief pause. This action is repeated. Pre
Soak cycles through a series of sprays followed
by a pause to allow the detergent to work on
the soils. The Pre Soak feature is followed by
the selected cycle. Using Pre Soak will extend
your wash cycle.
END OF CYCLE SIGNAL VOLUME
The End of Cycle Signal produces an audible
sound when the wash cycle is finished. This
signal is helpful when you are removing items
from the washer as soon as it stops. Select
High, Low, or Off.
OPERATING CONTROLS
PAUSE/CANCEL
Press PAUSE/CANCEL once to pause or stop
the washer at any time. Press PAUSE/CAN
-
CEL once to unlock the lid and add a garment.
Press START to complete the cycle from where
it was stopped. Press PAUSE/CANCEL twice
to stop the wash cycle. The washer will then
drain and turn off.
LID LOCK
When the Lid Lock status light glows, the washer
lid is locked.
NOTE: You must wait until the lid lock light
turns off before the lid can be opened.
NORMAL SOUNDS
Your new washer may make sounds your old
one didn’t. Because the sounds might be un
-
familiar, you may be concerned about them.
These sounds are normal.
DURING WASHING
If you select the Stain Cycle option, you will
hear a spin/spray noise at the start of the
cycle.
DURING DRAIN
If water is drained quickly from your washer
(depending on your installation), you may hear
air being pulled through the pump during the
end of draining.
DURING WASH AND SPIN
This washer does not have a transmission. The
motor provides direct drive for agitation and
spin. You will hear sounds that are different
from those of a conventional washer.
POWER
Press POWER to turn the washer on or off.
START
Press START to start your washer after a cycle
has been selected. Be sure all desired Modi
-
fiers and Options have been selected. The lid
must be closed for the washer to start.