Filter
Top Products
6-2
(F81)
Open/Close Door Lid
Lid flashes when the following conditions occur:
• User presses START with lid open.
• User presses START after 2 consecutive machine cycles without opening lid.
• The machine/motor control cannot detect the lid switch opening and closing properly.
• See TEST #8.
• See TEST #5.
(none)
(none)
Pump Out (lid opened)
Po flashes when drain pump begins pumping out water from tub upon activation by the door lid having been left open for
more than 10 minutes.
• Close door lid to stop drain pump.
If drain pump turns on when there is no water in tub,
Hot, Cold Reversed
HC flashes when the hot and cold inlet hoses are reversed.
• Make sure inlet hoses are connected correctly.
• If hoses are connected correctly, Automatic Temperature Control may be stuck in low resistance range.
(F80, 82,
84, 85)
Door Lock Failure
dL flashes if the following conditions occur:
• Door lid is not closed completely due to interference.
• Wash media buildup is preventing the lock bolt from extending.
• Check for lock interference with lid or lock bezel.
• Machine/motor control detects open door lid switch when attempting to lock.
• Machine/motor control cannot determine if door lid is in a locked state.
• See TEST #8.
(F83)
Door Unlock Failure
dU flashes if the following conditions occur:
• Excessive force on door lid is preventing lock bolt from retracting.
• Check pressure hose connection from tub to machine/motor control. Is hose pinched or kinked?
• If F then 1 repeats numerous times after POWER is pressed and the pressure hose connection is not pinched or kinked,
replace the machine/motor control.
• Wash media buildup is preventing lock bolt from retracting.
•
Machine/motor control cannot determine if door lid is in an unlocked state.
• See TEST #8.
(F68)
Pressure Signal Out-Of-Range
F then 1 flashes when the control detects an out of range pressure signal.
(F2)
Keypad/User Interface Failure
F then 2 flashes when in:
• Diagnostics Test mode if a stuck key is detected.
• Standby mode if there is a user interface mismatch.
DISPLAY
(Saved Code)
EXPLANATION AND RECOMMENDED PROCEDURE
• See TEST #4.