Filter
Top Products
3-16
Is the water inlet hose kinked?
Straighten the hoses.
Does the water level seem too low, or
does the washer appear to not fill com
-
pletely?
The Auto Water Level feature senses the size
of the load and adds the correct amount of
water for the load size. A different water level
may be selected by pressing LOAD SIZE.
Are you using Auto Water Level?
The Auto feature senses the size of the load
and adds the correct amount of water for the
load size.
Has a household fuse blown, or has a
circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If
the problem continues, call an electrician.
Is the washer in a normal pause in the
cycle?
The washer may pause during certain cycles.
Allow the cycle to continue.
Is the washer overloaded?
Wash smaller loads. See “Starting The
Washer,” page 3-3 for maximum load size.
Is there oversudsing?
Cancel the current cycle. Select SPIN ONLY
to drain the load. Re-select your desired cycle
and press START. Do not add detergent. Use
cold water.
Is the lid open?
The lid must be closed during operation. The
washer will not operate with the lid open.
Did you add more items to the load once
the washer started?
Once the load is wet, there may appear to be
space for more items. Do not add more than
1 or 2 garments after the cycle has started.
For best results determine load size with dry
items only.
•
•
•
•
•
•
•
•
•
Washer continues to fill or drain, or the
cycle seems stuck
Is the top of drain hose lower than the
control knobs on washer?
The top of the drain hose must be at least
39˝ (99 cm) above the floor. See “Drain
System,” page 2-3.
Does the drain hose fit too tightly in the
standpipe, or is it taped to the stand
-
pipe?
The drain hose should be loose yet fit se-
curely. Do not seal the drain hose with tape.
The hose needs an air gap. See “Installation
Instructions,” page 2-5.
Washer won’t drain or spin; water remains
in washer
Is the drain hose clogged, or the end of
the drain hose more than 96
˝ (244 cm)
above the floor?
See “Drain System,” page 2-3.
Is the lid open?
The lid must be closed during operation. The
washer will not operate with the lid open.
Wash/Rinse temperature
Are the hot and cold water inlet hoses
reversed?
If the hot and cold water inlet hoses are re-
versed, the washer will display an “HC” error
code at the end of the cycle. If an error code
does not appear but you are experiencing
poor washing performance, check to see
whether the inlet hoses are reversed. See
“Connect the Inlet Hoses,” page 2-6.
Are you washing many loads?
As your frequency of loads washed increases,
the water temperature may decrease for hot
and warm temperatures. This is normal.
•
•
•
•
•
•