Filter
Top Products
4-4
REMOVING THE WATER INLET/ DISPENSER VALVE
ASSEMBLY, POWER SUPPLY CORD, AND
MACHINE/MOTOR CONTROL & PRESSURE TRANSDUCER
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply.
3. Remove the console from the top of the
washer (see page 4-2 for the procedure).
WARNING
Power Supply Cord Machine/Motor Control
Water Inlet/Dispenser Valve Assembly
4. To remove the water inlet/dispenser
valve assembly (see the top right pho
-
to):
a) Disconnect the hot and cold water
hoses from the water inlets.
b) Release the locking tab and discon
-
nect the wire connectors from the wa
-
ter inlet/dispenser valve assembly so
-
lenoid terminals.
c) Release the locking tab and discon
-
nect the wire connector from the ther-
mistor.
Red
Yellow Thermistor
d) Tape the washer lid closed.
e) Using a putty knife, press and unhook the
two front top locks. The top locks are ap
-
proximately 6-1/2
˝ from the outside edge
of the washer.
Water Inlet/Dispenser Valve Assembly
Violet
Violet
White
Lift Top
Press Top Lock
6-1/2˝
Tape Lid
Tape Lid