Filter
Top Products
2-6
REMOVE DRAIN HOSE
FROM WASHER CABINET
Pull the corrugated drain hose out of the
washer by first grabbing the pull tie. Continue
to pull the hose until the end emerges. Do not
force excess drain hose back into the rear of
the washer.
LAUNDRY TUB DRAIN
OR STANDPIPE DRAIN
Connecting the drain hose form to the cor
-
rugated drain hose
To keep drain water from going back into
the washer:
Do not force excess drain hose into stand-
pipe. Hose should be secure but loose
enough to provide a gap for air.
Do not lay excess hose on the bottom of
the laundry tub.
FLOOR DRAIN
Do not install the drain hose form on to the
corrugated drain hose. You may need addi
-
tional parts. See Floor drain under “Tools and
Parts,” page 2-1.
•
•
A. Coupling
B. Washer
A B
sfeiler es
o
h niarD .A
e
soh
niard f
o
d
ne
ec
alP .
mr
of
fo dne e
n
o ot
ni
esoh nia
r
d
f
o d
ne
deeF.1
.
f
eile
r
esoh n
i
a
r
d eht o
t
ni m
r
of
fo d
n
e re
hto
eht
otn
i
d
e
ef
dna m
r
o
f
eht f
o
p
ot
e
h
t revo
e
s
oh
eht
d
neB
.2
esoh n
i
ard rehto
eht otni mro
f
eht fo dn
e
r
ehto eht hcattA .mrof eht
.mrof eht dnoyeb )mc 4.11("4-1/2 dnetxe tsum esoh ehT .feiler
"
5
.
4
)
m
c
4
.
11(
A
CONNECT THE INLET HOSES
1. Insert new flat washers (supplied) into
each end of the inlet hoses. Firmly seat
the washers in the couplings.
CONNECT THE INLET HOSES TO
THE WATER FAUCETS
Make sure the washer basket is empty.
2. Attach the hose labeled hot to the hot
water faucet. Screw on coupling by hand
until it is seated on the washer.
3. Attach the hose labeled cold to the cold
water faucet. Screw on coupling by hand
until it is seated on the washer.
4. Using pliers, tighten the couplings with
an additional two-thirds turn.
NOTE: Do not overtighten or use tape or seal-
ants on the valve. Damage to the valves can
result.
Clear the water lines
Run water through both faucets and inlet
hoses, into a laundry tub, drainpipe or buck
-
et, to get rid of particles in the water lines
that might clog the inlet valve screens.
Check the temperature of the water to
make sure that the hot water hose is con
-
nected to the hot water faucet and that the
cold water hose is connected to the cold
water faucet.
•
•
Tighten the couplings with an additional two-thirds turn.