Filter
Top Products
33
The dryer is equipped with a pneumatically operated heat reclaimer damper, which when opened, will recirculate
approximately fifteen percent (15%) of the dryer’s exhaust air.
The heat reclaimer damper is closed until ignition of flame has been established. Then, the damper piston is
actuated, opening the dampers recirculating fifteen percent (15%) of the exhaust air back over the gas burner
and into the tumbler (basket). The damper remains open for the rest of the drying cycle. On cool down, the
damper closes, exhausting ALL of the 13,000 cfm (368 cmm) which ensures a fast cool down of the load.
4. TIGHTEN TOP HEAT RECLAIMER NUTS DOWN
ONTO THE BOTTOM HEAT RECLAIMER NUTS.
3. THE DISTANCE BETWEEN THE TOP OF THE PLATE
TO THE BOTTOM OF THE NUTS MUST BE 1-3/16”
-3.00 cm- (see drawing below) IN ORDER TO OBTAIN
THE NUTS CLOSEST TO THE PISTON MUST BE
LOOSENED TO ONE PISTON WITH THE DAMPER
CLOSED. SNUG THE NUTS UP TO THE PLATE.
2. LOOSEN HEAT RECLAIMER ADJUSTMENT NUTS
ON ALL FOUR (4) CORNERS OF THE HEAT
RECLAIMER PISTON.
HEAT RECLAIMER ADJUSTMENT
1. REMOVE ELECTRICITY FROM THE UNIT.