Filter
Top Products
22
E. ELECTRICAL REQUIREMENTS
1. Electrical Requirements
It is your responsibility to have ALL electrical connections made by a properly licensed and competent
electrician to assure that the electrical installation is adequate and conforms with local and state regulations
or codes. In the absence of such codes, ALL electric connections, materials and workmanship must
conform to the applicable requirements of the National Electrical Code ANSI/NFPA NO. 70-LATEST
EDITION or in Canada, the CANADIAN ELECTRICAL CODES PARTS 1 & 2 CSA C22.1-1990 or
LATEST EDITION.
IMPORTANT: Failure to comply with these codes or ordinances or requirements stipulated in this
manual can result in personal injury or component failure.
NOTE: Component failure due to improper installation will VOID THE WARRANTY.
Each dryer should be connected to an independently protected branch circuit. The dryer must be
connected with copper wire ONLY. DO NOT use aluminum wire which could cause a fire hazard.
The copper conductor wire or cable must be of proper ampacity and insulation in accordance with electric
codes for making ALL service connects
NOTE: The use of aluminum wire will VOID THE WARRANTY.