EQQ1458I EQQ2010E
EQQ1458I DAILY PLANNING REPORT USER EXIT IS ACTIVE FOR THIS PRINTOUT
Explanation: The exit for daily planning print is activated.
System action: The job continues processing.
User response: None.
EQQ1459I DAILY PLANNING REPORT USER EXIT IS NOT ACTIVE FOR THIS PRINTOUT
Explanation: The exit for daily planning print is not activated.
System action: The job continues processing.
User response: None
EQQ1594E INVALID PARAMETER SPECIFIED IN SYSIN
Explanation: Parameters in the SYSIN statement must be a character string. Valid values are 01, 02, 03, 04, 05,
06, 07, 08, 09, 10, 11, 12, 13, and 14.
System action: The job is terminated.
User response: If the job was submitted outside TME 10 OPC, correct the parameters and then resubmit the job. If
the job was submitted from the Application Description dialog, contact your system programmer.
System programmer response: Check the batch job submit panels and make sure that the TME 10 OPC input field
verification logic has not been removed or changed. If the panels were not removed or changed, contact your IBM
representative.
EQQ1595I OUTPUT FIELDS HAVE BEEN TRUNCATED
Explanation: Lines longer than 120 characters have been truncated in the report.
System action: The run cycle description and special resource fields are truncated.
User response: None.
EQQ1596E NO PARAMETERS SPECIFIED
Explanation: No parameters were specified in the SYSIN statement for a batch job.
System action: The job is terminated and a return code of 8 is issued.
User response: Specify the necessary parameters and then resubmit the job.
EQQ2010E DAILY PLAN ENDS DUE TO ERRORS IN INPUT DATA. REFER TO DIAGNOSTIC FILE EQQDUMP
FOR MORE INFORMATION
Explanation: The Daily Plan program has detected an error in input data. The validation error action specified in the
BATCHOPT statement is to end the Daily Plan program.
System action: The Daily Planning program ends. No new current plan is created.
Problem determination: Refer to the preceding validation error message and data in the diagnostic file, ddname
EQQDUMP, to determine the cause of the error.
User response: If necessary, use the OPC dialog to remove incorrect records. After making corrections, resubmit
the Daily Plan batch job.
474 TME 10 OPC Messages and Codes
