EQQR000E EQQR013E
Chapter 22. EQQRnnn Messages
EQQR000E YOU ARE NOT AUTHORIZED TO ACCESS THE READY LIST
Explanation: You have attempted to access the ready list but you are not authorized to access it.
System action: The requested access to the ready list is rejected.
User response: Contact your security administrator if you require access to the ready list.
EQQR008E YOU ARE NOT AUTHORIZED TO ACCESS THE JS DATA SET
Explanation: You have attempted to access the job setup facility, but you are not authorized to access it.
System action: The requested access to the job setup facility is rejected.
User response: If you only want to browse the JCL, you need read access authority; if you want to update JCL, you
need update access authority. Contact your security administrator.
EQQR010I ERDR
ERC
£ TERMINATED
Explanation: Event reader
ERC
processing has completed and control is returned to the TME 10 OPC subsystem.
System action: Event reader
ERC
processing is terminated.
User response: None.
EQQR011I EVENT READER
ERC£
HAS BEEN REQUESTED TO STOP
Explanation: An event reader has been requested to stop while waiting for event data set positioning information to
become available.
System action: The event reader will free all acquired resources and terminate.
System programmer response: None.
EQQR012I ERDR
ERC
£ RESTARTED
Explanation: Event reader
ERC
has been restarted. This message is only issued for event readers that service the
NCF application at remote sites. The most likely reason for this is that the event reader is restarted with new event
dataset positions after a CP refresh, or the reader is restarted when an NCF session is reestablished after failure.
System action: Event reader
ERC
restart processing continues.
User response: None.
EQQR013E ERDR UNABLE TO LOAD MODULE EQQERBEX - INITIALIZATION IS TERMINATED
Explanation: An event reader task was unable to locate the EQQERBEX load module.
System action: The event reader initialization is terminated.
System programmer response: Stop the event readers using the MODIFY command. Make sure that the
EQQERBEX module resides in a load library that is accessible by TME 10 OPC, and then restart the event readers.
Copyright IBM Corp. 1991, 1998 249
