EQQN071E EQQN083E
EQQN071E AN ATTEMPT TO UPDATE THE NOERROR TABLE HAS FAILED
Explanation: A modify command was entered requesting the noerror table to be updated. One or more errors were
found while processing input NOERROR statements.
System action: The NOERROR table is not changed. TME 10 OPC continues normal processing.
User response: Review earlier error messages in the message log that describe initialization statement processing
errors. Correct all identified errors and reenter the modify command.
EQQN072I THE NOERROR TABLE HAS BEEN SUCCESSFULLY UPDATED.
Explanation: A modify command has caused TME 10 OPC to rebuild the NOERROR table from NOERROR
statements in the parameter library.
System action: TME 10 OPC continues normal processing and is using the updated NOERROR table.
User response: None.
EQQN080I THE LOG ARCHIVER TASK HAS STARTED
Explanation: The Job Tracking Log Archiver task has completed initialization and is ready to perform additional
work.
System action: Normal TME 10 OPC processing continues.
User response: None.
EQQN081I THE LOG ARCHIVER TASK HAS ENDED
Explanation: The Job Tracking Log Archiver task is ending normally after having been posted to stop processing.
System action: Normal TME 10 OPC processing continues.
User response: None.
EQQN082E NEXT JOB TRACKING LOG DATA SET, DDNAME
DDNAME
, IS NOT OPEN
Explanation: TME 10 OPC was unable to use the next job tracking log in a situation where current job tracking log
can no longer be used.
System action: The Normal Mode Manager subtask is stopped and the current plan is no longer available.
Problem determination: Review earlier messages in the message log data set to determine why the next job
tracking log is not open.
User response: Contact your system programmer.
System programmer response: Stop TME 10 OPC. Ensure that TME 10 OPC is authorized to update all job
tracking log data sets defined by currently specified (or defaulted) values of the JTLOGS and DUAL keywords of the
JTOPTS initialization statement. Reallocate any job tracking log data sets that had output errors. After making
necessary corrections, restart TME 10 OPC.
EQQN083E THE JTLOGS KEYWORD MUST SPECIFY A VALUE IN THE RANGE 2 TO 99
Explanation: The value specified for the JTLOGS keyword is not supported.
System action: The Normal Mode Manager subtask terminates.
TME 10 OPC administrator response: Contact your system programmer.
System programmer response: Correct the JTLOGS specification and then restart TME 10 OPC.
224 TME 10 OPC Messages and Codes
