EQQG014W EQQG107I
EQQG014W REQUEST TERMINATED BECAUSE TIME LIMIT IS EXCEEDED
Explanation: A general service request has terminated because the requesting process; a PIF program or a dialog
user, did not respond within 10 minutes.
System action: Processing continues.
User response: None.
EQQG015W REQUEST TERMINATED - REQUESTOR NO LONGER CONNECTED
Explanation: A general service request was terminated because the requesting process, a PIF program or a dialog
user, is no longer connected to the general service task. The connection can be lost if the requestor is cancelled, or if
a dialog user presses the ATTN (attention) key, after a request for service has been sent to the controller and before
a response has been received.
System action: Processing continues.
User response: None.
EQQG100E GDDM COULD NOT BE LOADED
Explanation: When requesting a graph, TME 10 OPC could not load GDDM*.
System action: The graph request is ignored. Processing continues.
User response: Contact your system programmer.
System programmer response: Make sure that the GDDM load library is part of ISPLLIB.
EQQG104W POSITION THE CURSOR ON AN ELEMENT IN THE GRAPHICAL AREA
Explanation: A graph selection command has been given, but the cursor was not located in the graphical area.
System action: The command is ignored. Processing continues.
User response: Position the cursor in the graphical area at or close to the element to be selected and reissue the
command.
EQQG105E DUMMY NODES ARE NOT VALID, REPOSITION CURSOR
Explanation: This node is a dummy node and as such has no data related to it.
System action: The system waits for you to respond.
User response: Specify another node for processing.
EQQG106I THE SPECIFIED ATTRIBUTE MUST BE NUMERIC. SEE GDDM MANUALS
Explanation: An invalid graphical attribute has been given.
System action: The attribute panel is re-displayed and prompts you for a correct attribute value.
User response: Correct the invalid attribute.
EQQG107I GDDM NOT ALLOWED IN SPLIT MODE
Explanation: The GDDM is not allowed in split-screen mode.
System action: The call to GDDM is disabled.
User response: Set the screen in single-screen mode and repeat the command.
Chapter 10. EQQGnnn Messages 109
