Notes:
1. If you are running SDLC, I.430, I.431, Channelized, or X.25 on a dial circuit, you
will be unable to use the set command to change the following parameters as
the software will use specific defaults:
v Any_inbound - any_inbound is set
v Calls - inbound
v Destination - default address
v Inbound destination - no destination inbound address
v Idle - 0
v Lid_out_addr - no LID name
v Lid_used - disabled
v Priority - 8
v Self_test_delay
2. If you are running a dial circuit on V.34, you will be unable to change the
following parameters:
v Bandwidth
v Callback
v Idle-char
v lid_out_addr
v timeslot
Syntax:
set
any_inbound
bandwidth...
callback...
calls...
destination...
idle...
idle-char...
inbound destination...
lid_out_addr...
lid_used...
net...
priority...
selftest-delay...
timeslot...
any_inbound
Specifies that inbound calls that do not match any other dial circuit will be
mapped to this circuit and accepted as inbound calls.
bandwidth
kbps
Sets the bandwidth, in Kbps, for I.430 and Channelized T1/E1 circuits.
Valid values:
For I.430: 64 or 128
Configuring Dial Circuits
Chapter 47. Configuring and Monitoring Dial Circuits 647
|
|
|
|
|
|
|
||
