A SERVICE OF

logo

Open as PDF
next previous
------------------------ -------
000000000009 YES
000000000100 YES
QoS Configuration
Use the qos-configuration command to display the ATM I/F 0 QOS Config> prompt
from which you can configure Quality of Service as described in “QoS
Configuration”.
Syntax:
qos-configuration
Remove
Use the remove command to remove an ESI from your ATM configuration. All ATM
components using this ESI should be reconfigured to use a different ESI. An ATM
component that attempts to use a removed ESI may not activate on the next router
restart.
Syntax:
remove
esi
esi-address
esi
esi-address
Address of End System Identifier.
Valid Values: Any 12 hexadecimal digits
Default Value:
none
Set
Use the set command to specify ATM network parameters.
Syntax:
set
max-data-rate
max-frame
max-config-selectors
max-calls
max-callers
max-mp-parties
trace
uni-version
network-id
max-data-rate
speed
Sets the default and upper bound for VCC traffic parameters of most LANE
and CIP connections. For example, this is the default PCR for best-effort
VCCs initiated by LE Clients. Signaled SCRs and PCRs cannot exceed this
ATM Interface Configuration Commands (Talk 6)
280
MRS V3.2 Software User’s Guide