Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
510975
24
Electrical Connection
Three-Wire Power Cord
1. Remove the screw and terminal block access
cover from the rear of the dryer unit cabinet.
2. Insert ends of direct wire through power supply
hole (containing proper strain relief) in rear of
dryer unit cabinet. Refer to Figure 15. Connect
the power cord, or direct wiring, to the
appropriate terminal block terminals using the
three wire-binding (10-32 x 3/8") screws from
the accessories bag in the envelope shipped
inside the dryer unit cylinder. If the dryer unit
had previously been connected with a four-wire
power cord, remove the four-wire power cord by
reversing procedures under Four-Wire Power
Cord instructions.
IMPORTANT: Use only a U.L. listed No. 10 A.W.G.
(copper wire only) three conductor power supply
cord kit rated 240 Volts (minimum) 30 Amperes
and labeled as suitable for use in a clothes dryer
unit.
3. Tighten these wire-binding screws firmly.
IMPORTANT: Failure to tighten these screws
firmly may result in wire failure at the terminal
block.
4. Secure the strain relief to the power cord, or
wires, where they enter the dryer unit cabinet.
5. Check the continuity of the ground connection
before plugging the cord into an outlet. Use an
acceptable indicating device connected to the
center grounding pin of the plug and the green
screw on the back of the cabinet.
6. Reinstall access cover and screw.
Figure 14
The dryer unit is grounded to neutral
conductor at the terminal block. If local
codes do not permit grounding through
the neutral, proceed as shown on
Four-Wire Connection instructions.
W148
To reduce the risk of electric shock,
disconnect the electrical service to the
dryer unit before proceeding.
W149
WARNING
D607I
1 Grounding Pin
2 Ground Screw on Back of Cabinet
3 Indicating Device (Must show continuity)
D6
0
2
1
3