Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
11
510975
Additional Security
Torx security screws are available (as optional
equipment at extra cost) for securing both lower access
panels to each dryer base. Order Part No. 62853.
A Torx bit, Part No. 282P4, is available (as optional
equipment at extra cost) for installing the Torx security
screws.
A Torx bit holder, Part No. 24161, is available (as
optional equipment at extra cost) to be used with the
Torx bit.
Slide Extension
(Coin Slide Models Only)
Remove two slide extensions, four screws and
lockwashers from the accesssories bag (located in
lower cylinder) and install the extension on the top of
the coin slide.
IMPORTANT: Slide extension must be attached to
top side of the coin slides to make them long enough
to activate the accumulator.
NOTE: This dryer unit, as shipped from the
factory, does not include the coin slides, coin
drawers, lock or keys. These coin slide kits (or
parts) must be ordered, at extra cost, according to
the purchaser’s requirements direct from the coin
kit manufacturer of your choice.
Timer Cams
(Coin Slide Models Only)
The dryer timers are factory equipped with a
45 minute timing cam. If this drying time is not
suitable to your installation, the following cams can be
found in the accessories bag (located in lower
cylinder).
ELECTRIC DRYERS
2-53242 Cams (30 Minutes)
2-53240 Cams (60 Minutes)
GAS DRYERS
2-53242 Cams (30 Minutes)
A 60 minute timing cam, Part No. 53240, is available
for the gas dryers as optional equipment at extra cost.
To change the timing cam:
1. Align notch in cam with a tooth on ratchet wheel.
2. Squeeze the ends of the two timing cam prongs
together.
3. Carefully lift timing cam off post.
NOTE: Adjust ratchet wheel and timing cam to
“OFF” position prior to putting dryer into use.
Refer to Figure 1 for proper position.
Figure 1
D775I
1 Retaining Prongs
2 Timing Cam
3 Notch
4 Levers
5 Off Position
6 Ratchet Wheel
7 On Position
D775I
2
3
4
5
6
1
7