Hardware Setup 13
E-EQ-MX7RG-B MX7 Reference Guide
Installing the Handstrap
Note: The handstrap cannot be used/installed when the MX7 has the trigger handle installed at
the same time.
An elastic hand strap is available for the MX7. Once installed, the hand strap provides a means for
the user to secure the computer to their hand. It is adjustable to fit practically any size hand and is
easily moved to allow installation or removal of the battery pack.
Note: Slide the bottom bracket out and away from the MX7 when replacing the main battery
pack.
Figure 1-10 MX7 With Handstrap Installed
Tool Required: #1 Phillips Screwdriver (not supplied by LXE)
Installation
1. Place the MX7, with the screen facing down, on a flat stable surface.
2. Attach the handstrap retainer bracket to the MX7 with the screws provided.
3. Slip the Handstrap Clip into the bracket at the base of the MX7.
4. Making sure the closed loop fastener surfaces on the handstrap are facing up, slide the strap
through the pin in the retainer bracket and the clip.
5. Fold each end of the strap over so that the closed loop fastener surfaces mate evenly.
6. Test the strap’s connection making sure the MX7 is securely connected to each end of the
strap connectors.
Check the closed loop fastener, retainer bracket and clip connections frequently. If they have
loosened, they must be tightened before the MX7 is placed into service again.
Periodically check the handstrap for wear and the connection for tightness. If the handstrap gets
worn or damaged, it must be replaced.
