Summit Client Configuration 187
E-EQ-MX7RG-B MX7 Reference Guide
LEAP w/o WPA Authentication
If the Cisco/CCX certified AP is configured for open authentication, set the Auth Type radio
parameter to “Open”.
If the AP is configured for network EAP only, set the Auth Type radio parameter to “LEAP”.
Start the Summit Utility by tapping the Summit Client icon.
Tap the Admin Login button on the Main panel. Enter the Administrator password and tap OK.
Tap the Config tab.
Enter the SSID of the Access Point assigned to
this profile.
Set Auth Type to Open.
Set EAP Type to LEAP.
Set Encryption to Auto WEP.
Tap the Credentials button.
Figure 5-9 Configure a Summit Profile with LEAP w/o WPA
Figure 5-10 LEAP Credentials
Enter the Username or Domain \Username in the Credentials popup text entry box.
Enter the Password. Tap OK.
Tap the Commit button to save the new profile configuration.
Perform a Warm Reset function to connect using the new profile configuration.
Please see “WPA/LEAP Authentication” later in this section to configure the radio for WPA
LEAP.
