162 Single Application Configuration
MX7 Reference Guide E-EQ-MX7RG-B
Input from the keyboard or Input Panel is accepted with the restriction that the normal key must
be pressed from the keyboard when switching modes. The hotkey sequence is displayed in the Hot
key text box with “Shift”, “Alt”, and “Ctrl” text strings representing the shift state keys. The
normal keyboard key completes the hotkey sequence. The hotkey must be entered via the keypad.
Some hotkeys cannot be entered via the Input Panel. Also, hotkeys entered via the SIP are not
guaranteed to work properly when switching operational modes.
For example, if the ‘Ctrl’ key is pressed followed by ‘A’, “Ctrl+A” is entered in the text box. If
another key is pressed after a normal key press, the hotkey sequence is cleared and a new hotkey
sequence is started.
A normal key is required for the hotkey sequence and is unlike pressing the normal key during a
mode switch; this key can be entered from the SIP when configuring the key. However, when the
hotkey is pressed to switch modes, the normal key must be entered from the keypad; it cannot be
entered from the SIP.
Password
Move the cursor to the Password text box. The passwords entered in the Password and Confirm
Password fields must match. Passwords are case sensitive.
When the user exits the Administrator Control panel, the two passwords are compared to verify
that they match. If they do not match, a dialog box is displayed notifying the user of the error.
After the user closes the dialog box, the Security Panel is displayed and the password can then be
entered and confirmed again. If the passwords match, the password is encrypted and saved.
See Also: Passwords
Status Panel
Figure 4-9 Status Panel
Note: If your Status Panel does not look like the figure shown above, you may have the Multi-
Application version.
Use the Status panel to view the log of previous AppLock operation and to configure which
messages are to be recorded during AppLock operation.
As the status information is stored in the registry and accumulates during AppLock configuration
and operation, it is very important that the administrator periodically clear the status information
