Hardware Setup 11
E-EQ-MX7RG-B MX7 Reference Guide
Hardware Setup
Installing Trigger Handle (Optional)
The MX7 can be purchased with a customer-installable pistol grip handle. The handle enables the
user of the MX7 to hold the unit while pointing and activating the scanner with the trigger on the
handle. Pressing the trigger activates the scanner and functions the same as the Scan key on the
keypad. With the handle installed the Scan key on the keypad remains active. The trigger
duplicates the operation.
The handle is built of a durable and flexible plastic that will not detach from the MX7 if the unit is
dropped. The trigger handle is a mechanical device. Battery or external A/C power is not required
for operation of the trigger handle. The trigger handle does not need to be removed when
replacing the main battery pack.
Either the trigger handle is attached to the MX7 or the handstrap is attached, but not both.
Figure 1-8 Trigger Handle Attach Points
Handle Installation
Equipment Needed: Torque wrench capable of torquing to 3±1 in/lb (.34± .11 N/m) .
1. Place the MX7, with the screen facing down, on a flat stable surface.
2. Remove the main battery pack.
3. Slide the locking tab on the underside of the pistol grip into the slot at the back of the battery
compartment and press it firmly into place.
4. Ensure that the battery can be inserted into the battery compartment before securing the pistol
grip handle into place.
5. Attach the pistol grip handle to the MX7 (as shown above) with the two screws provided.
6. Torque the Pan Head Screws to 3±1 in/lb (.34±.11 N/m).
7. Test the handle's connection making sure the MX7 is securely connected to the handle.
Periodically check the pistol grip handle for wear and the connection for tightness. If the handle
gets worn or damaged, it must be replaced. If the pistol grip connection loosens, it must be
tightened before the MX7 is placed in service.
