112 Settings | Control Panel Options
MX7 Reference Guide E-EQ-MX7RG-B
Parameter Function
Good Scan / Bad Scan
Vibration
The default setting is Disabled. Enable this parameter when a tactile
response on a good scan, bad scan or both event is desired. Scan
sounds are accompanied by a tactile response when the internal
scanner Sound parameter is enabled.
Enable short, medium or long duration for each selection (good
scan/bad scan).
COM1 Tab
Access: | Settings | Control Panel | Scanner | COM1 tab
Factory Default Settings
COM1 Port (external serial port)
Baud Rate 9600
Stop Bits 1
Parity None
Data Bits 8
Figure 3-27 Scanner Panel – COM1
Integrated laser scanner default values are 9600 Baud, 8 data bits, 1 stop bit and No parity.
EV-15 scanner default values are 19200 Baud, 8 data bits, 1 stop bit and No parity.
If these values are changed, the default values are restored after a cold boot or reflashing.
Note: COM1 does not support 5V switchable power on Pin 9 for tethered scanners.
