16-84 ELECTRICAL SYSTEM
Fuse
30A Main Fuse Removal
•
Remove:
Right S
ide Cover (see Frame chapter)
30A Main Fuse Connector [A]
•
Pull out the main fuse [B] from the starter relay with needle
nose pl
iers.
Junction Box Fuse Removal
•
Remove the seats (see Frame chapter).
•
Unlock the hook to lift up the lid [A].
•
Pull the fuses [B] straight out of the junction box with nee-
dle nose pliers.
Fuse Installation
•
If a fuse fails during operation, inspect the electrical sys-
tem to determine the cause, and then replace it with a
new fuse of proper amperage.
•
Install the junction box fuses on the original position as
specified on the lid.
15A ECU Fuse Removal
•
Remove:
Seats (see Frame chapter)
•
Unlock the hook [A] to pull the lid [B].
•
Pull out the ECU Fuse from the fuse box.
Fuse Inspection
•
Remove the f use (see Fuse Removal).
•
Inspect the fuse element.
If it is blown out, replace the fuse. Before replacing a
blown fuse, always check the amperage in the affected
circuit. If the amperage is equal to or greater than the
fuse rating, check the wiring and related components for
a short circuit.
Housing [A]
Fuse Elem ent [B]
Terminals [C]
Blown Element [D]
CAUTION
When replacing a fuse, be sure the new fuse
matches the specified fuse rating for that circuit.
Installation of a fuse with a higher rating may cause
damage to wiring and com ponents.
