ELECTRICAL SYSTEM 16-41
Ignition System
Camshaft Position Sensor Peak Voltage Inspection
•
Remove:
Fuel Tank (see Fuel System (DFI) chapter)
Camshaft Position Sensor Lead Connector [A] (discon-
nect)
•
Set the hand tester [B] to t he 10 V DC range.
•
Connect the peak voltage adapter [C] to the hand tester
and Camshaft Position Sensor leads in the connector.
Speci
al Tool -
Hand T
ester: 57001–1394
Recommended Tool- Peak Voltage Adapter
Type: KEK-54-9-B
Bran
d: KOWA SEIKI
Connections:
Camshaft Position
Sensor Lead
Adapter Hand Tester
Black
←
Red
→
(+)
Yellow
←
Black
→
(–)
•
T urn the ignition switch and engine stop switch on.
•
Pushing the starter button, turn the engine 4 ∼ 5sec-
onds with the transmission gear in neutral to measure the
Camshaft Position Sensor peak voltage.
•
Repeat the m easurement 5 or m ore times.
Camshaft Position Sensor Peak Vo ltage
Standard:
0.2 V or more
If the peak voltage is lower than the standard, inspect the
Camshaft Position Sensor.
Stick Coil (Ignition Coil together with Spark Plug Cap)
Removal
•
Remove the fuel tank (see Fuel System (DFI) chapter).
•
Unscrew the thermostat bracket bolt [A].
○
If removing the stick coil #2 or #3.
•
Disconnect the stick coil connectors [A].
•
Pull the stick coil #1 [B] off the spark plug.
•
Take out the camshaft position sensor connector [ C] from
the bracket (see Camshaft Position Sensor Removal).
•
Pull the stick coil #2 [D] off the spark plug.
CAUTION
Do not pry the connector part of the coil while re-
moving the coil.
