A SERVICE OF

logo

CLUTCH 6-9
Clutch
Clutch Removal
Remove:
Engine Oil (drain, see Engine Oil Change section in the
Periodic Maintenance chapter)
Clutch C over (see Clutch Cover Removal)
Clutch Spring Bolts [A]
Clutch Springs
Clutch Spring Plate [B] (with thrust bearing and pusher
[C])
Remove:
Friction Plates, Steel Plates
Spring, Spring Seat
Clutch Hub Nut [A]
Holding the clutch hub [B], remove the nut.
Special Tool - Clutch Holder [C]: 57001–1243
Remove:
Clutch Hub
Spcer
Using the two 4 mm (0.16 in.) bolts [A], pull out the sleeve
[B], needle bearing [C] and clutch housing [D].
Remove the spacer.
Clutch Installation
Install the following parts on the drive shaft.
[A] Spacer
[B] S leeve
[C] Needle Bearing
[D] Clutch Housing
[E] Spacer
[F] Clutch Hub
[G] Washer
[H] Nut