A SERVICE OF

logo

Open as PDF
next previous
7-12 ENGINE LUBRICATION SYSTEM
Oil Pump
•
Fit the pin [A] of the oil pump cover [B] into the hole [C] in
the crankcase.
•
Install:
Pins [A]
Water Pump Body [B]
•
Install:
Impeller [A] and Bolt [B]
•
Tighten:
Torque - Water Pump Impeller Bolt: 10 N·m (1.0 kgf·m, 87
in·lb)
•
Install:
Pins [C]
Water Pump Cover and Bolts
Torque - Water Pump Cover Bolts: 11 N·m (1.1 kgf·m, 95
in·lb)
•
Install:
Water Pipes [A]
•
Tighten:
Torque - Water Pipe Fi tting Bolts [B]: 11 N·m (1.1 kgf·m, 95
in·lb)
•
Install the water hose [C] so that the white mark faces
outward.
•
Tighten:
Torque - Water Hose Clamp Screws [ D]: 2.0 N·m (0.2 kgf·m,
17 in·lb)