16-44 ELECTRICAL SYSTEM
Ignition System
WARNING
To avoid extremely high voltage shocks, do not
touch the spark plugs or tester connections.
•
Turn the ignition switch and the engine stop switch ON.
•
Pushing the starter button, turn the engine 4 ∼ 5 seconds
with the transmission in neutral to measure the primary
peak voltage.
•
Repeat the measurements 5 times for one stick coil.
Stick
Coil Primary Peak Voltage
Stand
ard: 88 V or more
•
Repeat the test for the other stick coil.
If the reading is less than the specified value, check the
following.
Stick Coils (see Stick Coil Inspection)
Crankshaft Sensor (see Crankshaft S ensor I nspection)
If the stick coils, and crankshaft sensor are normal, check
the ECU (see Fuel System (DFI) chapter).
Spark Plug Removal
•
Refer to the Electrical System in the Periodic Mainte-
nance chapter.
Spark Plug Installation
•
Refer to the Electrical System in the Periodic Mainte-
nance chapter.
Spark Plug Cleaning and Inspection
•
Refer to the Electrical System in the Periodic Mainte-
nance chapter.
Spark Plug G ap Inspection
•
Refer to the Electrical System in the Periodic Mainte-
nance chapter.
