14-10 STEERING
Handlebar
Handlebar Removal
•
Remove:
Clutch
Lever Assembly [A]
Left Handlebar Switch Housing [B]
Front Brake Master Cylinder [C]
Right H
andlebar Switch Housing [D]
Handlebar Holder Bolts [E]
•
Remove the handlebar holders [F] and then pull out the
handle
bar [G].
•
Remove the cotter pins [A].
•
Unscrew the mounting nuts [B] and remove the handlebar
lower clamps [C].
Handlebar Installation
•
Install the handlebar lower clamps [A], noting the letters
“L” [ B] and “R” [C].
•
Tighten:
Torque - Handlebar Lower Clamp Nuts: 34 N·m (3.5 kgf·m,
25 ft·lb)
•
Align the punch mark [A] on the handlebar and the corner
edge [B] on the lower clamp.
•
Tighten the front clamp bolts first, and then the rear clamp
bolts. There will be a gap [A] at the rear part of the clamp
after tightening.
Torq ue - Handlebar Clamp Bolts: 25 N·m ( 2.5 kgf·m, 18
ft·lb)
