A SERVICE OF

logo

Open as PDF
next previous
SUSPENSION 13-21
Swingarm
Swingarm Installation
•
Apply plenty of grease to the ball bearing, needle bearings
and grease seals, and add plenty of grease to the grease
nipple.
•
Install the collars [A].
○
Place the right collar [A] on the stopper [B] inside the
frame [C].
•
Insert the pivot shaft into the frame from the right side.
•
Tighten the pivot shaft so t hat the clearance [D] between
the collar [A] and the frame [C] com e to zero mm.
•
Tighten:
Torque - Swingarm Pivot Shaft Nut: 127 N·m (13 kgf·m, 94
ft·lb)
•
Tighten the pivot locknut, using the socket wrench.
S
pecial Tool -
S
ocket Wrench: 57001–1370
Torque - Swingarm Pivot Shaft Locknut: 98 N·m (10.0
kgf·m, 72 ft·lb)
Swingarm Bearing Removal
•
Remove:
Swingarm
Collars [A]
Grease Seals [B]
Sleeve [C]
Circlip (right side) [D]